Control Chief TM6000 Betreibershandbuch PDF herunterladen (Seite 77)

TM 10-3930-660-10

0006 00-7

OPERATION UNDER UNUSUAL CONDITIONS - CONTINUED 0006 00

OPERATE IN SANDY OR DUSTY CONDITIONS - CONTINUED

2. At Halt or Parking

a. Contact Maintenance to lubricate the 6K forklift at more frequent intervals. Clean all fittings and lubrication

openings thoroughly before lubricating to prevent entrance of dust or sand with the lubricant.

b. When not in use, cover the operator compartment, and utilize whatever means are available to protect the engine

compartment from the entry of windblown dust or sand.

FORDING

1. Check the water depth, allowing for inconsistency of the bottom. Do not attempt to ford even the narrowest stream

that is more than 30 in. (762 mm) deep.

2. Make certain all gauges are indicating normal operating pressure and temperatures.

3. Use the range select lever to shift the transmission into the low speed range (position 1), and speed the engine up to

minimize the danger of stalling. Enter the water slowly to minimize surges of backwash into the engine compartment.

Fording speed should not exceed 3 to 4 mph (5 to 6 kph).

NOTE

In the event of complete submersion, contact Maintenance for appropriate disposition.

4. Contact Maintenance to lubricate the vehicle completely, as soon as possible, after fording.

409-050

RANGE

SELECT

LEVER

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 200 201

Keine Kommentare

Control Chief TM6000 Betreibershandbuch Seite 77