Control Chief TM6000 Betreibershandbuch PDF herunterladen (Seite 55)

TM 10-3930-660-10

0005 00-3

OPERATION UNDER USUAL CONDITIONS - CONTINUED 0005 00

OPERATE ENGINE - CONTINUED

CAUTION

• If the oil pressure fluctuates or drops, or if the warning light is illuminated, stop the engine and find the cause.

Do not operate the engine at oil pressure lower than 10 psi (69 kPa).

• If oil pressure does not register within 15 seconds after the engine starts, stop the engine or serious damage may

occur. Stop the engine by turning the starter-run control switch to the OFF position.

7. After the engine starts, operate the engine just above idle for 30 to 60 seconds before driving the vehicle. Check the

readings on the gauges before moving the vehicle. Return engine speed to idle before moving the range select lever.

MOVE FORKLIFT

WARNING

• Do not travel with the fork auto leveler switch in the ON position. It is possible to drop a load which may

cause load damage, injury or death.

• Use care when backing up. Have someone direct you if you cannot see where you are going. Watch clearances.

CAUTION

The forks extend beyond the end of the carriage. The operator must be aware of the swing of the forks when

turning and allow for adequate clearance between the forks and other objects.

1. Operating Safety

a. Do not allow riders on the vehicle.

b. Understand lifting limitations of forklift and keep the vehicle under control. DO NOT try to exceed limitations.

409-024

BRAKE

ACCELERATOR

TRAVEL

PARKING

PEDAL

SELECT

LEVER

BRAKE

LEVER

PEDAL

RANGE SELECT

LEVER

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 200 201

Keine Kommentare

Control Chief TM6000 Betreibershandbuch Seite 55