Control Chief TM6000 Betreibershandbuch PDF herunterladen (Seite 62)

TM 10-3930-660-10

0005 00-10

OPERATION UNDER USUAL CONDITIONS - CONTINUED 0005 00

STOP ENGINE - CONTINUED

5. Turn all lights and accessories off.

6. Allow engine to idle for three minutes.

7. Turn starter-run control switch to the OFF position.

8. Perform After Operation Checks listed in the Preventive Maintenance Checks and Services (WP 0012 00).

OPERATE IN ROUGH TERRAIN

WARNING

Do not travel with fork auto leveler switch in the ON position. It is possible to drop a load which may

cause in load damage, injury or death.

INSTALL MLRS LIFTING HOOK AND STOP ASSEMBLY

With the MLRS lifting hook and stop assembly attached to the MLRS pod and stop tube on the forks, the 6K forklift can

handle MLRS pods. The following procedures provide instructions for use of the lifting tool and stop tube.

1. The MLRS lifting hook and stop are stored on the fork-

lift deck. Loosen the two wing nuts and lift the MLRS

lifting hook from the stop tube.

2. Attach the lifting hook to the MLRS pod to be moved. The hooks on the tool must be mounted to the lifting bar on the

MLRS pod. Tighten the wing nuts on the hooks.

3. Remove the stop tube from the vehicle deck and slide

the stop tube all the way onto the forks. Tighten the

wing thumbscrews to secure the stop tube on the forks.

409-032

WING NUTS

STOP TUBE

MLRS

LIFTING

HOOK

409-033

MLRS

LIFTING HOOK

WING

NUTS

WING

TUBE

STOP

THUMB-

SCREWS

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 200 201

Keine Kommentare

Control Chief TM6000 Betreibershandbuch Seite 62