Control Chief TM6000 Betreibershandbuch PDF herunterladen (Seite 157)

TM 10-3930-660-10

0017 00-3

PRIMARY AND SECONDARY AIR FILTER MAINTENANCE - CONTINUED 0017 00

SERVICE - CONTINUED

CAUTION

Do not tap the element against a hard surface as this damages the element.

5. Remove loose dust by tapping element with palm of your hand. DO NOT use a hard surface.

WARNING

Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when

drying parts with compressed air. Use a maximum of 30 psi (207 kPa) when cleaning components. DO NOT

direct compressed air against human skin. Failure to follow this warning may result in injury or death. Make

sure air stream is directed away from user and other personnel in the area. To prevent injury, user must wear

protective goggles or face shield.

6. To remove remaining dust, use compressed air under

30 psi (207 kPa). Blow the air up and down the pleats

from the inside of the element. Be careful not to dam-

age or tear paper element.

CAUTION

DO NOT wash element in fuel oil, oil, gasoline, or solvent. DO NOT use compressed air to remove water

from an element.

7. To clean oily or sooty element, wash thoroughly with warm water and non-foaming detergent. Rinse element with clean

water and allow element to air dry. Clean outer cover and rubber evacuator valve with soap and water.

409-067

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 200 201

Keine Kommentare

Control Chief TM6000 Betreibershandbuch Seite 157