Control Chief TM6000 Betreibershandbuch PDF herunterladen (Seite 71)

TM 10-3930-660-10

0006 00-1

OPERATION UNDER UNUSUAL CONDITIONS 0006 00

GENERAL

This work package provides the operator with additional instructions for operating in various environments and emer-

gency situations. In addition to normal preventive maintenance, special care must be taken to keep the 6K forklift operational

in extreme temperatures and other environmental conditions.

SLAVE STARTING

WARNING

When slave starting tractor:

• Use NATO slave cable that does NOT have loose or missing insulation.

• DO NOT proceed if suitable cable is not available.

• DO NOT use civilian-type jumper cables.

• DO NOT allow disabled and booster vehicles to come in contact with each other at any time during

slave starting.

Failure to follow this warning may result in injury or death to personnel.

NOTE

Ensure that both disabled vehicle and booster vehicle are equipped with serviceable NATO slave receptacles.

1. Connect NATO slave cable to booster vehicle slave receptacle.

2. Connect other end of slave cable to NATO slave receptacle of disabled vehicle.

3. Ensure disabled vehicle’s battery disconnect switch is in ON position.

4. Start booster vehicle and run at a speed just above idle.

5. Wait approximately five minutes, then start disabled vehicle. If engine fails to start, notify Unit Maintenance.

6. After starting disabled vehicle, return booster vehicle to idle.

7. Remove NATO slave cable from disabled vehicle, then from booster vehicle.

409-051

SLAVE CABLE

RECEPTACLE

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 200 201

Keine Kommentare

Control Chief TM6000 Betreibershandbuch Seite 71